Long Lee dust cover reassembly |
Post Reply |
Author | |
gmkmd
Newbie Joined: August 23 2015 Location: Pennsylvania Status: Offline Points: 2 |
Post Options
Thanks(0)
Posted: August 23 2015 at 7:59pm |
Does anyone know how to get the dust cover back on a Long Lee bolt? It seems like you need three hands, to simultaneously get the front edges under the two lugs and the back end up and into the groove near the safety. Is there some trick or special tool I am missing?
|
|
Pukka Bundook
Senior Member Joined: February 02 2015 Location: Canada Status: Offline Points: 1369 |
Post Options
Thanks(0)
|
Morning GM,
I saw your Q on another forum and you seem short of answers! I don't recall a lot of difficulty when I had one, but time & memory and all that ... I think you just locate it over the lugs, then press down and push forwards and it snaps into place. No special tool needed as far as I know. never had a special tool myself. Good luck! Richard.
|
|
A square 10
Special Member Donating Member Joined: December 12 2006 Location: MN , USA Status: Offline Points: 14452 |
Post Options
Thanks(0)
|
that was my experience as well , placement is crucial but if you study first then push it should snap in place ,
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |