Bore Guide |
Post Reply |
Author | |
JD 303
Groupie Joined: May 25 2021 Location: Arkansas Status: Offline Points: 49 |
Post Options
Thanks(0)
Posted: June 18 2021 at 12:54pm |
I made a prototype bore guide.
It works well,but I'm redoing it with clean,new tubing. The tube started out ,as a 12" piece of 3/8" steel fuel line. I left one end flared,for the bolt end,for easier rod insertion,and cut 4" off the other end,for the chamber. I used my resizing tool,to make the chamber end fit without binding. The collar to support it is a steel bushing,1/2" long 3/8" id,and turned down to 0.580 od. I drilled and tapped a hole in the bushing ,for a 10-24 cap screw. This locks the collar onto the tube,once it's inserted,and by holding the protruding (flared ) end,The collar is slid forward,and the screw is installed,after the oil slot is up,and Then turned down in the lug recess,and tightened. Pictures will follow if I can get them to load. |
|
Expect the unexpected,..but don't expect the unexpected to be the way you expected.
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |