Enfield-Rifles.com Homepage
Forum Home Forum Home > Enfields > After Market Enfields
  New Posts New Posts RSS Feed - Kustom 7.62x51 barrel...
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Kustom 7.62x51 barrel...

 Post Reply Post Reply
Author
Message
Goosic View Drop Down
Senior Member
Senior Member
Avatar

Joined: September 12 2017
Location: Phoenix Arizona
Status: Offline
Points: 2559
Post Options Post Options   Thanks (0) Thanks(0)   Quote Goosic Quote  Post ReplyReply Direct Link To This Post Topic: Kustom 7.62x51 barrel...
    Posted: April 08 2019 at 8:22pm
It is coming along nicely. Still more to do however...
Back to Top
Sponsored Links


Back to Top
Zed View Drop Down
Special Member
Special Member
Avatar
Donating Member

Joined: May 01 2012
Location: France
Status: Online
Points: 3144
Post Options Post Options   Thanks (0) Thanks(0)   Quote Zed Quote  Post ReplyReply Direct Link To This Post Posted: April 09 2019 at 11:12am
another project on the way Goosic!
Looking forward to the results.
It's nice to be important, but it's more important to be nice!
Back to Top
Goosic View Drop Down
Senior Member
Senior Member
Avatar

Joined: September 12 2017
Location: Phoenix Arizona
Status: Offline
Points: 2559
Post Options Post Options   Thanks (0) Thanks(0)   Quote Goosic Quote  Post ReplyReply Direct Link To This Post Posted: April 09 2019 at 1:26pm
I just finished welding in the drift pin holes where the rear sight was and smoothing out the barrel lines...
Back to Top
Canuck View Drop Down
Special Member
Special Member
Avatar
Donating Member

Joined: January 17 2012
Location: Agassiz BC
Status: Offline
Points: 2581
Post Options Post Options   Thanks (0) Thanks(0)   Quote Canuck Quote  Post ReplyReply Direct Link To This Post Posted: April 09 2019 at 1:35pm
That's.....beautiful!!!!
Castles made of sand slip into the sea.....eventually
Back to Top
Honkytonk View Drop Down
Senior Member
Senior Member
Avatar

Joined: December 30 2017
Location: Brandon Mb
Status: Offline
Points: 2303
Post Options Post Options   Thanks (0) Thanks(0)   Quote Honkytonk Quote  Post ReplyReply Direct Link To This Post Posted: April 09 2019 at 2:09pm
Very nice! What finish are you planning? Blueing? Other?
Back to Top
Goosic View Drop Down
Senior Member
Senior Member
Avatar

Joined: September 12 2017
Location: Phoenix Arizona
Status: Offline
Points: 2559
Post Options Post Options   Thanks (0) Thanks(0)   Quote Goosic Quote  Post ReplyReply Direct Link To This Post Posted: April 09 2019 at 3:34pm
Cold bluing.  I have been taking measurements on the facing and seating area of the threaded end so I can thread it all the way in and have the flat on the barrel facing up so I do not have to re-index an extractor cut 180° opposite the original.  I will have to reface the bolthead as well. If all of what I am doing pans out I will have a bolthead at .620 and a barrel custom fit to my No4 action. Basically starting out with a new barrel.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.01
Copyright ©2001-2018 Web Wiz Ltd.